| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Brake | Section: Brake Control/Dynamic Control System | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000001JRF004X |
| Title: BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: BRAKE ACTUATOR: REMOVAL (2008 Sequoia) | ||
REMOVAL
1. DISCONNECT VSC ACTUATOR CONNECTOR
|
(a) Pull the release bar and disconnect the VSC actuator connector. NOTICE:
Be careful not to allow brake fluid to enter the removed connector. |
2. REMOVE BRAKE TUBE
|
(a) Use tags or make a note to identify the reconnection locations. |
|
(b) Using a union nut wrench, disconnect the 2 brake tubes from the VSC actuator. |
|
(c) Using a union nut wrench, remove the 2 brake tubes from the brake master cylinder. |
3. DISCONNECT BRAKE TUBE
|
(a) Using a union nut wrench, disconnect the 4 brake tubes from the VSC actuator. |
(b) Remove the clamp from the VSC actuator bracket.
4. REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY
|
(a) Remove the 3 nuts and VSC actuator with actuator bracket. NOTICE:
Do not damage the brake lines or wire harness. |
|
|